[Skip to Content]
University of Illinois Extension
Berries (cranberries, raspberries, strawberries)

Berries (cranberries, raspberries, strawberries)

Treat stains as soon as possible after staining. The older the stain, the more difficult it will be to remove.

All stain removal methods should be applied prior to laundering washable garments. Stains that have been laundered and dried are almost impossible to remove.

Washable Fabrics

What you will need

  • Liquid hand dishwashing detergent
  • White vinegar
  • Rubbing alcohol
  • Enzyme presoak product
  • Chlorine bleach or oxygen bleach
Caution: Never mix chlorine bleach with ammonia - fumes are hazardous.

Steps to Clean

  1. Soak for 15 minutes in mixture of one quart lukewarm water, one-half teaspoon liquid hand dishwashing detergent and one tablespoon white vinegar. Rinse.
  2. Sponge with rubbing alcohol, using light motions from center to edge of stain.
  3. Soak for 30 minutes in one quart warm water with one tablespoon enzyme presoak products.
  4. If color stain remains, launder in chlorine bleach if safe for the fabric, or in oxygen bleach.

Carpet

What you will need

  • Dull knife
  • Wet vacuum (for spilled liquid)
  • Detergent
  • 3% Hydrogen peroxide

Steps to Clean

  1. Blot up as much of the stain as is possible by blotting with a white paper towel or scraping with a dull knife. A wet vacuum is useful if a large quantity of liquid was spilled.
  2. If spot has dried, saturate the tufts in the affected area with tap water (do not over wet). Allow to remain for about 1 minute and blot. If the spot is being removed using water, continue until the spot is completely removed. Blot dry and apply the paper towels and brick. If the stain is not completely removed, continue.
  3. Apply a small quantity of detergent solution to the spot. (To make the detergent solution mix 1/4 teaspoon of a hand dishwashing detergent which does not contain lanolin or bleach with 1 quart of water) Use a blotting motion to work the detergent into the affected area. If spot is being removed continue applying detergent and blotting with a white paper towel until spot is removed.
  4. Rinse with tap water using a spray bottle, blot to remove excess moisture.
  5. Spray lightly with water, do not blot this time; apply pad of paper towels and brick and allow to dry.
  6. If there is still some stain on the carpet and blotting is not removing it, then moisten the tufts in the stained area with 3% hydrogen peroxide. Let stand for on (1) hour. Blot and repeat until carpet is stain free. Light will cause peroxide to change back to water so no rinsing is necessary. Apply pad of paper towels and weight down with brick.